PDA

View Full Version : Rubicon Express Bumpstop Installation


JSimmons
07-11-2008, 21:56
Hello everyone,

Just a quick stupid question. I have a set of the Rubicon Express front lower bumpstops (part #: RE1380 http://www.rubiconexpress.com/Products.aspx?pn=1720&Vid=39EB796732415 ).

I cannot figure out how this part is supposed to be installed. The RE website says it goes inside of the spring on the bottom, but there's no place to screw it into on the bottom spring perch. ??? I know I'm missing something here.

Any help would be much appreciated.
miljeep
07-11-2008, 21:59
gotta drill it bro. We had to drill holes for my 06. Just drill holes in the center of that plate on the bottom and botl those bad boys in.
Fifthpro
07-11-2008, 22:30
Do you remember the 1980's Super Glue commercials? With the guy and the hard hat.......here is your chance to test that product!
JSimmons
07-12-2008, 02:29
Cool. Thanks for the replies guys. Probably not going to superglue it though. Would be entertaining though.
enil01
07-12-2008, 02:41
Do you remember the 1980's Super Glue commercials? With the guy and the hard hat.......here is your chance to test that product!

Ok so what happens if he gets superglue on both sides of the bumpstop and bottoms out? Now that would be entertaining.
JSimmons
07-12-2008, 11:53
Ok so what happens if he gets superglue on both sides of the bumpstop and bottoms out? Now that would be entertaining.

:D:D:D Enter Dremel Tool.
JSimmons
07-13-2008, 00:53
Everything is good to go. Went in just fine. Using the drill that is.