User Tag List

Results 1 to 4 of 4

Thread: transfer linkage

  1. #1
    Member reservoirdogg26's Avatar
    Join Date
    Aug 2009
    Location
    Fort Lee
    Posts
    776

    Branch
    Army
    Status
    Serving
    Served
    1995 to Present

    Closest Installation

    Fort Lee
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default transfer linkage

    ok here it is, since i lifted the jeep suspension and body i cant go into 4 low without phyisicaly holding the shifter in position and even then it pops out. ive tried to adjust it but just cant find a happy medium so that i can shift in all positions, it binds pretty bad and i know that i'm gonna have to bend linkages or add washers or something along those lines to get it to work properly, its an automatic, anybody out there got pics or info on what i should do before i break something doing what i think is right?
    " if you can read this, thank a teacher.
    If you are reading it in English, thank a Soldier"

    I READ TODD DID

  2. #2
    Junior Member
    Join Date
    Oct 2008
    Location
    Colorado Springs
    Posts
    463

    Branch
    Marine Corps
    Status
    Served
    Served
    1980 to 1984

    Closest Installation

    Fort Carson
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    You didn't give any info about the kit(s) you installed so it's kind of difficult to be specific.

    You need to relocate the the pivot point for the t-case linkage with the bracket that was supplied with your body lift.

    Take a look at the bracket installation instructions in the following link. About 3/4 of the way down the page.
    http://www.roughcountry.com/install/1157.pdf
    http://zhvac.webs.com/

    9/11 - WE WILL NEVER FORGET!! (<---<<click)

  3. #3
    Member reservoirdogg26's Avatar
    Join Date
    Aug 2009
    Location
    Fort Lee
    Posts
    776

    Branch
    Army
    Status
    Serving
    Served
    1995 to Present

    Closest Installation

    Fort Lee
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    thats the same kit, the rc 1 1/4 body and the 3.5 coil lift but the bracket that was supplyed dosent mount and since i didnt do the t-case drop i really didnt think i needed it
    " if you can read this, thank a teacher.
    If you are reading it in English, thank a Soldier"

    I READ TODD DID

  4. #4
    Junior Member
    Join Date
    Oct 2008
    Location
    Colorado Springs
    Posts
    463

    Branch
    Marine Corps
    Status
    Served
    Served
    1980 to 1984

    Closest Installation

    Fort Carson
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Did you install a motor mount lift to match the body lift?
    http://zhvac.webs.com/

    9/11 - WE WILL NEVER FORGET!! (<---<<click)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the MJ Supporter Membership for a little less than $0.06 a day and get more space, 2 MJ Stickers and no banners ads. [Check it out]