Sounds like you got a bad clutch release bearing.
im getting a chattering whenever my clutch pedal is depressed all the way ,but if i push it in about 1/4 the way ,the chatters stops.it has a brand new clutch kit in it.does anyone have any ideas to what my problem is.
Sounds like you got a bad clutch release bearing.
do you find clutch release bearings next to the blinker fluid?
Playing aside, did you change out your throw out bearing when you did the clutch?
This sounds like the beginning of the throwout bearing going bad.
does it chatter when the pedal is all the way out also? or just when pushing in to release the clutch??
is it better /worse/not there when your moving in gear pressing on the gas?
is it there when in neutral at engine idle?
did you replace the clutch?
what the throwout bearing replaced?
was the clutch aligned at install using the correct alignment tool? or did someone just wiggle the tranny around till it all fit?
were the correct bolts reused with the new clutch?(they have a shorter head for clearance)
"Some people wonder their whole lives if they will ever make a difference. Marines don't have that problem." Pres. Ronald Reagan
Army vs Marines = http://www.youtube.com/watch?v=_2M7ckkxQLU
Was there any oil residue in the old clutch(from a leaky rear main). Did you clean or resurface the flywheel(if needed)....
It chatters when the pedal is all the way out but stops when the pedal is pushed roughly 1/4th the way in.
Its gets worse when the throttle is pushed.
It does still chatter when in nuetral.
The throw out bearing was replaced.
The alignment tool that came with the kit was used in the install.
The bolts were the same one that came from the old one.
Get the MJ Supporter Membership
for a little less than $0.06 a day and
get more space, 2 MJ Stickers and no banners ads. [Check
it out] |
Bookmarks