So, I started the prep work for the Herculining.

**miljeep** · 06-01-2008, 16:05

Today I ripped out the carpet and with the help of some kind folks here, removed the rear and passenger seats. I also disconnected the rear seat belts and then stared at the jeep for about 2 hours wondering what I go myself into.

This week I will do all the prep work and hopefully have some anchor points welded in the rear of the jeep. I should be herculining the jeep this coming weekend.

**Nikester** · 06-01-2008, 16:30

I have been thinking of doing this to my YJ. How are you going to apply it Spray it, roller it, or brush it? I had Line X spray a bedliner in my pickup and it turned out nice but they want $550 to do the inside of my YJ and thats with me removing everything. I thought that was too high.

**E5EDDIE** · 06-01-2008, 16:33

I may be able to swing by during the week Miljeep, I'd be glad to give a hand...

**enil01** · 06-01-2008, 16:39

Keep your floor mats I lost mine and my feet ended up wearing through the herculiner under the pedals.

**vajeeper** · 06-01-2008, 17:32

I may be able to swing by also...won't be much help but I can bring some

**korisu56** · 06-01-2008, 18:59

Hooray

!!

**miljeep** · 06-01-2008, 19:45

Took out the part of my console that has the sub woofer in it. I also tried to get the rails for the rear seat off, but ran into some issues trying to get the front two torx bolts out. I will wait until I have more help for that so someone can apply downward pressure while the bolt is turned.

This week I will remove the front of the console and start prepping the inside to get rid of the glossy paint as instructed in the herculiner directions.

I will use the foam ear plugs as suggested in another post here, but come Saturday, all the prepwork and most of the taping off will be done.

**Hogwild** · 06-02-2008, 08:36

Did you already buy the Herc stuff?

I had done this years ago with my old CJ. The prep was not bad...I think I spent a couple of hours on it sanding and degreasing. The application was very easy...I used the roller and brush method. I'm looking a doing something similar to this with my TJ but I think I'm going to use the "Raptor" product...the Herc stuff was just a little too rough...the "Raptor" stuff is less abrasive.

Make sure you wear some gloves, long sleeve shirt and pants. It took well over a week for the stuff to wear off my arms.